Page 6 For technical questions, please call 1-888-866-5797. Item 59098
SAFETY OPERATION MAINTENANCESETUP
20. Transport tool safely. Always disconnect battery
when moving the tool. Carry the tool by the
handle and avoid contact with the Trigger.
21. Hold tool away from head and body.
During operation the tool may
kick back causing injury.
22. Do not drive fasteners into a workpiece
that has people, utility lines, or other
objects behind or inside it.
23. Keep balance while using this tool.
Keep area below clear if working
in an elevated location.
24. Do not engrave or stamp anything into
the housing to avoid weakening it.
25. The warnings and precautions discussed in this
manual cannot cover all possible conditions and
situations that may occur. It must be understood
by the operator that common sense and caution
are factors which cannot be built into this
product, but must be supplied by the operator.
26. Maintain labels and nameplates on the tool.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
27. This product is not a toy.
Keep it out of reach of children.
28. People with pacemakers should consult their
physician(s) before use. Electromagnetic fields in
close proximity to heart pacemaker could cause
pacemaker interference or pacemaker failure.
Lithium Battery Safety Warnings
LITHIUM BATTERIES STORE
A LARGE AMOUNT OF ENERGY AND
WILL VENT ACTUATE OR EXPLODE
IF MISTREATED:
1. Keep Battery Pack dry.
2. DO NOT DO ANY OF THE FOLLOWING
TO THE BATTERY PACK:
a. Open,
b. Drop,
c. Short-circuit,
d. Puncture,
e. Incinerate, or
f. Expose to temperatures greater than 265°F.
3. Charge Battery Pack only according
to its Charger’s instructions.
4. Inspect Battery Pack before every use;
do not use or charge if damaged.
SAVE THESE INSTRUCTIONS.
To Next Page
Loading...
