Bauer 21681-B - General Operating Instructions; General Safety and Operational Advice

Page 5<&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1Item 58162
?@<6AQRS6;@ACRED@CEA6E@ET6 ?6AFS
12. F#*%47,5/#%$&%#'//&($%)&(Z/"*4*%
).*8*Y*(%/(,4$"4,71%Never hold a small
ZRUNSLHFHLQRQHKDQGDQGWKHWRROLQWKH
RWKHUKDQGZKLOHLQXVH&ODPSLQJDVPDOO
ZRUNSLHFHDOORZV\RXWRXVH\RXUKDQGV
to control the tool. Round material such
DVGRZHOURGVSLSHVRUWXELQJKDYHD
tendency to roll while being cut, and may
FDXVHWKHELWWRELQGRUMXPSWRZDUG\RX
13. E*Y*(%7,>%$.*%/&)*(%$&&7%9&)8%'8$"7%$.*%
,44*##&(>%.,#%4&5*%$&%,%4&5/7*$*%#$&/1%
7KHVSLQQLQJDFFHVVRU\PD\JUDEWKHVXUIDFH
DQGSXOOWKHSRZHUWRRORXWRI\RXUFRQWURO
14. @2$*(%4.,83"83%$.*%+"$#%&(%5,Z"83%,8>%
,9='#$5*8$#I%5,Z*%#'(*%$.*%4&77*$%
8'$I%4.'4Z%&(%,8>%&$.*(%,9='#$5*8$%
9*Y"4*#%,(*%#*4'(*7>%$"3.$*8*91%Loose
DGMXVWPHQWGHYLFHVFDQXQH[SHFWHGO\
shift, causing loss of control, loose rotating
FRPSRQHQWVZLOOEHYLROHQWO\WKURZQ
15. X&%8&$%('8%$.*%/&)*(%$&&7%)."7*%4,((>"83%
"$%,$%>&'(%#"9*1%Accidental contact with the
VSLQQLQJDFFHVVRU\FRXOGVQDJ\RXUFORWKLQJ
SXOOLQJWKHDFFHVVRU\LQWR\RXUERG\
16. ;*3'7,(7>%47*,8%$.*%/&)*(%$&&7]#%,"(%
Y*8$#1%The motor’s fan will draw the
dust inside the housing and excessive
DFFXPXODWLRQRISRZGHUHGPHWDO
may cause electrical hazards.
17. X&%8&$%&/*(,$*%$.*%/&)*(%$&&7%
8*,(%27,55,+7*%5,$*(",7#1%6SDUNV
could ignite these materials.
18. X&%8&$%'#*%,44*##&("*#%$.,$%(*H'"(*%
7"H'"9%4&&7,8$#1%Using water or other liquid
coolants may result in electrocution or shock.
19. Maintain labels and nameplates on the tool.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
20. Avoid unintentional starting.
Prepare to begin work before
turning on the tool.
21. Do not depress the spindle lock when
starting or during operation.
22. Do not leave the tool unattended when the
switch is on. Turn off the tool, before leaving.
23. Use clamps (not included) or other practical
ways to secure and support the workpiece to
a stable platform. Holding the work by hand
or against your body is unstable and may
lead to loss of control and personal injury.
24. Contains Li-Ion battery. Battery must be
recycled or disposed of properly. Do not
open, crush, heat above 140° F or incinerate.
25. This product is not a toy.
Keep it out of reach of children.
26. People with pacemakers should consult their
physician(s) before use. Electromagnetic
fields in close proximity to heart pacemaker
could cause pacemaker interference or
pacemaker failure. In addition, people with
pacemakers should:
• Avoid operating alone.
• Do not use with power switch locked on.
• Properly maintain and inspect
to avoid electrical shock.
• Properly ground power cord. Ground
Fault Circuit Interrupter (GFCI) should
also be implemented – it prevents
sustained electrical shock.
27. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.