Page 11For technical questions, please call 1-888-866-5797.Item 58215
SAFETYOPERATIONMAINTENANCE SETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Release the Trigger and unplug the tool from its electrical outlet
before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM FLYING FRAGMENTS:
Use only bonded reinforced or diamond cut-off wheels for your power tool. Just because
an accessory can be attached to your power tool, it does not assure safe operation.
Installing/Replacing Saw Wheel (sold separately):
1. Remove Screws from both sides of Base Plate.
Remove the Base Plate.
2. Open Latches, then remove Wheel Guard.
3. While holding Spindle Lock, remove Bolt with
included Hex Wrench by turning clockwise.
4. Remove Small Flange and Outer Flange, then
remove Wheel.
Do not remove Washer or Inner Flange.
5. Install a new Wheel with directional
arrow pointing in the same direction as
the arrow on the Wheel Guard.
WARNING! TO PREVENT SERIOUS INJURY:
Wheel must be rated to at least 4,300 RPM.
6. Replace Outer Flange with flat side facing
in, then replace Small Flange.
7. Replace Bolt and tighten securely with included
Hex Wrench by turning counterclockwise.
8. Reattach Wheel Guard and secure with Latches.
9. Reattach the Base Plate.
Hex
Wrench
Spindle
Lock
Wheel
Outer
Flange
Bolt
Inner
Flange
Wheel
Guard
Latch
Small
Flange
Washer
Base
Plate
Depth Adjustment
1. Loosen the Wing Bolt on the Depth Guide
and adjust Base Plate as necessary.
2. Tighten the Wing Bolt securely.
Wing
Bolt
Cutting Depth
Base Plate
Depth Guide
To Next Page
Loading...
