Operation
Starting the equipment
• Switch the battery main switch to position "I".
• Set the fuse switch of the main fuse "F1" to position "I".
✓ The power supply is connected.
• Close all doors and maintenance flaps and mount the protective coverings.
• Risk of causing damage to equipment! Uncontrolled movements of the equipment
can cause damage to the components. Set all operating elements to the "0" position. Unlock
EMERGENCY-STOP. Switch off the hydraulic pilot control.
Starting the diesel engine
Diesel engines have an ether starting aid installed for starting at low ambient temperatures. If the
diesel engine does not start, perhaps the cartridges of the ether starting aid are empty and must be
replaced with new ones. Further information can be found in the enclosed additional documentation
from the diesel engine manufacturer.
Ignition lock overview:
0 Ignition off
1 Ignition on (preheating)
2 Starting the diesel engine
• Risk of causing damage to diesel engine! A cold diesel engine can be damaged
when operated at full load. Cold diesel engines should first be brought to the operating temper-
ature at idling speed.
• Risk of causing damage to the AT system! If the AT system is not fully started, its
electronics can be damaged. First switch ignition key from position (1) to position (2), if the AT
system is not fully started.
• Preheat and start the diesel engine by turning the ignition key.
✓ Diesel engine is running.
✓ The equipment is ready for operation.
To Next Page
Loading...
