Baumalight TRL620D - Check Hydraulic Fluid Level (AW32 or MV22 Is Recommended)

8. Slowly pour oil into the valve cover to raise oil
level to the F (full) mark.
NOTICE
Prevent engine damage.
Do not overll crankcase.
B
C
9. Replace ller cap and dipstick.
10. Close hydraulic cooler and tighten knobs (A).
Check Hydraulic Fluid Level
Check hydraulic uid level before the engine is rst
started and every 10 hours. AW32 is recommended
for general conditions and climates. MV22 is
recommended for colder climates.
Attachments can raise or lower the hydraulic uid
level. If a new attachment is connected, hydraulic
uid needed to ll the lines, cylinders or motor will
lower the hydraulic tank uid level. Check uid level
each time a different attachment is connected.
1. Skidsteer must be parked on a level surface,
lift arms fully lowered, engine stopped and key
removed.
A
B
2. Check uid level in sight glass (A). Hydraulic
uid should ll approximately 75% of the sight
glass. If the level is low, add enough uid to
raise it to the proper level.
3. Clean the area around the ller neck of the
hydraulic tank.
4. Remove the cap (B) from ller neck and add
hydraulic uid as needed.
5. Install the cap (B) on ller neck.
15