Baumalight TRL620D - User Manual

Other manuals for Baumalight TRL620D

Operator's Manual40 pages

Questions and Answers

Z
zmartinezSep 23, 2025
Why does the fuse keep blowing on my Baumalight TRL620D Utility Vehicle?
- G
  Gary SpenceSep 23, 2025
  If a fuse is blown in your Baumalight Utility Vehicle, it could be due to several reasons: * An overloaded 12 Volt receptacle. Unplug the load on the receptacle and replace the fuse. * Solenoid failure. Test the solenoid, replace it if necessary, and replace the fuse. * Exposed wires. Check for worn or damaged wiring, repair the wires or replace the harness if necessary, and replace the fuse.
K
Kevin AndersonAug 23, 2025
What to do if my Baumalight Compact Loader unit will not move?
- A
  amyleblancAug 23, 2025
  If your Baumalight Compact Loader won't move, make sure the park brake is disengaged and that the operator is standing on the operator platform, verifying the switch is engaged. Also, check the fuse on the circuit from the Lofa panel and replace it if necessary. You can find the fuse in the harness located behind the Lofa instrument panel in the engine compartment. Finally, check for power to the boom valve by checking if the light on the boom valve solenoid (A) connector is on with the engine stopped and the ignition switch in the on position. If the light is not on, check the fuse. If the fuse is good, check the wiring between the boom valve and fuse block. Also, the operator on board switch might not function properly, check the switch operation and replace it if necessary.
M
Mark GreenAug 25, 2025
Why is the hydraulic fluid overheating in my Baumalight Compact Loader?
- M
  millerseanAug 26, 2025
  The hydraulic fluid in your Baumalight Compact Loader may be overheating because the hydraulic fluid level is low, so add hydraulic fluid. Alternatively, the hydraulic cooler might be clogged, so clean the cooler.
J
Jessica RobbinsAug 27, 2025
What causes a Baumalight Compact Loader engine to crank but not start?
- N
  nancy93Aug 27, 2025
  If your Baumalight Compact Loader's engine cranks but doesn't start, it could be due to several reasons: The auxiliary hydraulic control might be turned on, so turn it off. The battery could be discharged, so charge and load test it, replacing it if necessary. It might be too cold. There could be a solenoid failure, so test and replace it if needed. Also, check for worn or damaged wiring and repair or replace the harness if necessary.
P
Pamela WangAug 27, 2025
How to fix a Baumalight Compact Loader boom that will not raise?
- D
  Dawn BarkerAug 27, 2025
  If the boom on your Baumalight Compact Loader won't raise, ensure the operator is standing on the operator platform and the switch is engaged, and that the park brake is disengaged. Check the fuse on the circuit from the Lofa panel, replacing it if necessary. You can find this fuse in the harness behind the Lofa instrument panel in the engine compartment. Also, check for power to the boom valve by checking if the light on the boom valve solenoid (A) connector is on with the engine stopped and the ignition switch in the on position. If the light is not on, check the fuse. If the fuse is good, check the wiring between the boom valve and fuse block.
K
Kayla SmithSep 16, 2025
What to do if the hydraulic cooler fan is not running on my Baumalight TRL620D?
- W
  William FitzgeraldSep 17, 2025
  If the hydraulic cooler fan on your Baumalight Utility Vehicle is not running, check the fan operation and the fuse.
M
Michael WilliamsSep 14, 2025
What to do if my Baumalight TRL620D engine will not crank over?
- D
  Deanna AnthonySep 14, 2025
  If the engine of your Baumalight Utility Vehicle will not crank over, start by checking the fuses. The fuse block is located behind panel (A) on the right side. Also, inspect for worn or damaged wiring, repairing the wires or replacing the harness if needed.
D
Desiree BrowningSep 15, 2025
What to do if the hydraulic filter is clogged in my Baumalight Utility Vehicle?
- P
  Paul Jones PhDSep 15, 2025
  If you find that the hydraulic filter in your Baumalight Utility Vehicle is clogged, you should replace it.
D
Devin KellySep 6, 2025
What to do if the hydraulic filter is clogged on my Baumalight Compact Loader?
- R
  randy77Sep 6, 2025
  Replace the filter on your Baumalight Compact Loader.
K
karen78Sep 3, 2025
How to fix Baumalight Compact Loader when engine will not crank over?
- D
  Donna JordanSep 3, 2025
  If the engine of your Baumalight Compact Loader won't crank over, replace the main fuse located inside the Lofa instrument panel. You'll need to remove the instrument panel faceplate to access the fuse. Also, check for worn or damaged wiring and repair the wires or replace the harness if necessary.