Check Engine Air Filter And Precleaner
Check air lter pre cleaner (A) and air lter (B)
before startup and every 10 hours. Remove and
clean as needed.
A
B
Check Hydraulic Hoses
1. Skidsteer must be parked on a level surface,
park brake engaged, lift arms fully lowered,
engine stopped and key removed.
2. Check hydraulic hoses for wear and damage
before startup and every 10 hours. Replace
worn or damaged hoses.
Check Park Brake Operation
Check park brake operation before startup and
every 10 hours or more often when conditions
warrant.
Check Hydraulic Fluid Level
1. Skidsteer must be parked on a level surface,
park brake engaged, lift arms fully lowered,
engine stopped and key removed.
A
B
2. Check uid level in sight glass (A). Hydraulic
uid should ll approximately 75% of the sight
glass. If the level is low, add enough uid to raise
it to the proper level. AW32 is recommended
for general conditions and climates. MV22 is
recommended for colder climates.
3. Clean the area around the ller neck of the
hydraulic tank.
4. Remove the cap (B) from ller neck and add
hydraulic uid as needed.
5. Install the cap (B) on ller neck.
39
To Next Page
Loading...
