Baumalight TRL620D - Check Operator on Board Safety Switch; Every 20 Hours; Inspect Tracks; General Inspection

Check Operator On Board Safety Switch
1. Lower lift arms to ground, stop engine. Test
switch operation before startup and every 10
hours.
2. Stand on operators platform (A) and start
engine.
A
3. Step off operators platform. The drive and
boom functions should be disabled if safety
switch functioning correctly. If drive and boom
functions are not disabled, switch engine
off and contact a Baumalight dealer. Do not
operate skidsteer if operator on board safety
switch is not functioning correctly.
Inspect Tracks
Lower lift arms to ground, stop engine and remove
key. Inspect tracks for wear and damage before
startup and every 10 hours.
General Inspection
Lower lift arms to ground, stop engine and remove
key. Inspect skidsteer for damage and worn parts.
Repair or replace parts as needed.
5.3 Every 20 Hours
Lubrication
Skidsteer must be parked on a level surface, park
brake engaged, lift arms fully lowered, engine
stopped and key removed.
Pump grease into grease into ttings on quick
attach latch pins every 20 hours.
42