Baumatic BCG905SS - Gas adjustment (Conversion to LPG for the oven and grill)

36
rom
e the
control knob and make further adjustments to the gas flow,
o IMPORTANT: On completion carry out a gas tightness test.
t rill)
ll work must be carried out by a GASSAFE
registered engineer.
e cooker from the electricity
upply before changing the injectors and/or adjusting the
o Free the burners from their
fixing screws.
tipulated injector
for the new gas supply (see table
on page 33 - 34).
d grill injectors.
MPORTANT: After changing the injectors YOU MUST follow the
inimum flow adjustment section below.
o Refit the control knob.
o Make sure that the flame does not go out by quickly turning f
maximum flow to minimum flow. If it does then remov
testing it again once the adjustment has been made.
Gas adjus ment (Conversion to LPG for the oven and g
A
IMPORTANT: Always isolate th
s
minimum flow of the burners.
o Unscrew the injectors and replace
them with the s
IMPORTANT: You must change the oven an
I
m