23
o After a few seconds, you will hear the appliance begin to fill with
water and the wash program will have started.
Changing the wash program
o Turn off the power using the ON/OFF button.
o Wait for a minute and then open the door of the appliance.
o After a minute, close the door firmly, so that you hear the door
lock click shut.
o Turn the appliance on by using the ON/OFF button and wait for 5
seconds before pressing the program selection button.
o Press and hold down the program selection button of the wash
program that was in progress for 3 seconds to cancel the wash
program. Then press another program selection button to choose
the correct wash program.
o Select any program options that you want to use (e.g. delay
start or half load).
o After a few seconds, you will hear the appliance begin to fill with
water and the wash program will have started.
At the end of a wash program
o At the end of a wash program, an audible signal will sound for a
period of time.
o Use the ON/OFF button to switch the dishwasher off.
o IMPORTANT: You should leave the appliance for 15 minutes
BEFORE opening the door. This will allow the steam generated
from the final rinse(s) to dry the dishes.
o Carefully open the door of the appliance and leave it ajar for a
few minutes and allow any remaining steam to disperse.
o WARNING: Hot steam may escape when the door is first
opened, so care should be taken.
o Unload the dishwasher; you should take care in case any of the
items are still warm.
o IMPORTANT: If you leave the door of the dishwasher shut and
do not unload the dishwasher for a prolonged period of time,
then you may get water droplets reforming on the washload.
To Next Page
Loading...
