Cleaning the spray arms
The spray arms should be cleaned regularly, to prevent hard water
deposits from clogging the spray arm jets and bearings.
o To remove the lower spray arm, gently pull it upwards.
o Wash the lower spray arm in warm, soapy water and use a soft
brush to clean the jets.
o Rinse the lower spray arm thoroughly and then reassemble the
spray arm back in its original position.
o The other spray arms cannot be removed from the machine and
must be cleaned in situ.
o If you notice that any of the holes in the spray arms are blocked,
you should carefully use a sharp object, such as a needle to clear
the blockages in the holes (as shown in the drawing above).
Cleaning the control panel
IMPORTANT: Do not use any abrasive cleaner or household polish on
either the control panel or operating parts.
o Wipe over the control panel using a brand new damp cloth with
warm water.
29
To Next Page
Loading...
