Baumatic BDI631 Insrtuction Manual

38
The dishwasher must be secured to the worktop, this can be done in
one of two ways:-
o to the
using two wood screws.
o les in the brackets at the
dishwasher cabinet.
o These screws should be full
o Marble/granite worktop- T
will mean that it is impossible to put a screw through the
underneath of the worktop.
o On either side of the front edg
there is a rubber stopper. Yo
stoppers, to reveal a pre-drilled hole on either side of the
dishwasher.
o Secure the dishwasher to the cupboard either side of it, by
screwing a wood screw through the pre-drilled holes into
the cupboards. These screws should be fully tightened.
o The rub
original
Before first use
You should check the following before
time:-
o That the dishwasher is level and fixed in position.
o That the water tap is fully open.
o That there are no leaks at either end of the drain or inlet hoses.
o That the inlet and outlet hose are fully tightened.
o That the inlet and outlet hoses are not kinked.
o That the power is switched on.
o That the water softener has been filled with 1 litre of water and
salt.
o That the rinse aid dispenser has been filled.
Securing the dishwasher
Standard worktop- Secure the dishwasher
underside of the worktop by
You should screw through the ho
top of the
y tightened.
he material of the worktop
e of the dishwasher cabinet,
u should remove the rubber
ber stoppers should then be refitted into their
position.
using the appliance for the first

Baumatic BDI631 Specifications

General

Door color	Not applicable
Appliance placement	Fully built-in
Control panel color	Stainless steel
Washing class	A
Noise level	53 dB
Number of place settings	12 place settings
Number of washing programs	5
Water consumption per cycle	16 L

Weight and Dimensions

Depth	540 mm
Width	595 mm
Height	850 mm