27
Please refer to the conditions of guarantee that appear on the
warranty card that you receive with the appliance.
IMPORTANT: Baumatic Ltd. operates a policy of continuous
improvement and reserves the right to adjust and modify its
products without prior notification.
General troubleshooting
PROBLEM POSSIBLE
CAUSES
WHAT TO DO
Dishwasher
doesn’t
run
Fuse blown or the
circuit breaker has
tripped
Power supply is not
switched on
Water pressure is
low
Replace the fuse or reset the circuit
breaker. Remove any other
appliances that are sharing the same
circuit with the dishwasher.
Make sure that the dishwasher is
turned on and that the door is closed
securely.
Make sure that the power cord is
fully plugged into the wall socket.
Check that the water supply is
connected properly and that the
water is turned on.
Drain pump
doesn’t stop
Overflow The system is designed to detect an
overflow. If it does, then it will run
the drain pump continuously when
there is power to the appliance.
Noise Some audible sounds
are normal
Utensils are not
secure in the baskets
or something small
has dropped into the
basket
Motor hums
You will get a level of operating noise
during a wash cycle, in particular
when food is being removed from
items and when the detergent
dispenser places the tablet into the
tub.
Ensure that everything is loaded as
per Baumatic’s loading instructions.
If the dishwasher is not going to be
used for a period of time, then you
should make sure that the appliance
is set on a wash program once a
week. Otherwise the seal around the
motor may dry out and cause noise.
Suds in the
tub
Improper detergent
use
Spilled rinse aid
Ensure if you are using 3 in 1
detergent tablets, in conjunction with
rinse aid and salt that the levels are
set correctly.
Always wipe up any excess rinse aid
or rinse aid spillages immediately.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
