Changing the wash program
o Open the door slightly and then wait a few seconds.
o Press and hold down the program selection button for 3 seconds
to cancel the wash program. Then use the program selection
button to choose the correct wash program.
o Select any program options that you want to use (e.g. delay
start).
o Close the door firmly, so that you hear the door lock click shut.
o After a few seconds, you will hear the appliance begin to fill with
water and the wash program will have started.
At the end of a wash program
o The time display will flash for 8 seconds and a buzzer will sound.
o If you have used the delay start mode, the time display will flash
for 8 seconds but the buzzer will not sound.
o Open the door of the appliance.
o Use the ON/OFF button to switch the dishwasher off and unload
the dishwasher.
The 3 in 1 wash program
Make sure that the water softener has been filled with salt
and that the water softener has been set to its lowest
setting.
Make sure that the rinse aid dispenser has been set to an
appropriate level.
THIS WASH PROGRAM MUST BE SELECTED IF YOU ARE USING 3
IN 1 DETERGENT. IF YOU USE ANY OTHER WASH PROGRAM
WITH 3 IN 1 TABLETS, THEN YOU MAY GET POOR WASH
RESULTS.
22
To Next Page
Loading...
