Connecting to the mains water supply
IMPORTANT: Do not connect the appliance to your mains
water supply using an old or an existing water inlet hose.
The inlet hose supplied with the dishwasher is the ONLY one
that should be used.
DO NOT CONNECT THE WATER INLET HOSE TO A HOT
WATER TAP.
o The inlet hose will be located inside the cabinet of the dishwasher.
o Connect the water inlet hose to a threaded water tap that has a
3/4” thread and to the inlet hose connector on the appliance.
o Fully tighten the inlet hose to the water tap and the dishwasher.
IMPORTANT: The inlet hose is fitted with an aqua
stop. This MUST be fitted in the upright position, as
shown in the above diagram.
36
To Next Page
Loading...
Need help?
General
