Cleaning the door
o To clean the edge around the outside of the door, you should use
a soft, damp cloth only.
o To prevent water from penetrating the door lock or electrical
components, DO NOT use a spray cleaner of any kind.
o DO NOT use any abrasive cleaner or scouring pads on the inner
or outer surfaces, as they may cause damage to them.
E1
o Longer than expected fill time or drain time.
9 Check the water pressure of your mains water supply.
9 Clean the mesh filter that sits in the inlet hose.
9 Ensure that the inlet hose is not kinked or crushed.
9 Make sure the water tap that the machine is connected to is turned
on fully.
9 Check that the outlet hose is not kinked or crushed and that it’s
positioned correctly (as per the installation instructions).
E4
o The machine has sensed water in the base.
9 Check that the outlet hose is not kinked or crushed.
9 Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
9 The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
E8
o Open or short circuit
9 Motorised valve
o Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o Turn the machine on using the ON/OFF button and wait for 5
seconds.
o Press and hold down the delay start button and the ON/OFF
button, until the appliance switches off.
28
To Next Page
Loading...
