23
Changing the wash program
IMPORTANT: This should only be attempted when the cycle has
only just started, otherwise the detergent tablet may have
already released or you could have hot water escaping.
o Slightly open the door of the appliance and turn off the power
using the ON/OFF button.
o Wait for a minute before fully opening the door of the appliance.
o Turn the appliance on by using the ON/OFF button and wait for 5
seconds before pressing the program selection button.
o Press and hold down the program selection button for 3 seconds
to cancel the wash program. Then use the program selection
button to choose the correct wash program.
o Select any program options that you want to use (e.g. delay
start).
o Close the door firmly, so that you hear the door lock click shut.
o After a few seconds, you will hear the appliance begin to fill with
water and the wash program will have started.
At the end of a wash program
o The time display will flash for 8 seconds and a buzzer will sound.
o If you have used the delay start mode, the time display will flash
for 8 seconds but the buzzer will not sound.
o Open the door of the appliance.
o Use the ON/OFF button to switch the dishwasher off and unload
the dishwasher.
Setting a delay start
It is possible to delay the start of the wash program for up to a
maximum of 24 hours.
o Check whether the appliance needs rinse aid or salt adding to it.
o Pull out the top and bottom baskets, then load them in
accordance with the loading instructions.
o Push the top and bottom baskets fully back into position.
To Next Page
Loading...
