The following things should be checked before starting the dishwasher.
The content of this manual is very he lpful to the users.
After installation, please make sure to keep this manual.
1
The dishwasher is level and fixed properly
2
T he i nlet va lv e i s o pen
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
T he inl et an d dr ain hos es a re kno tte d
7
All packing materials and printings should be taken out from the dishwasher
Extension Hose
If you needa drain hose extension, make sure to use a similar drain hose.
It mu st be no lon ger t han 4 m etres; otherw ise the c leaning effe ct of the di shw asher could be reduced.
Wa t e r O u t l et
Connect the wat er d rain h ose. The dr ain h ose mu st be correctly f itted t o av oid w ate r leaks.
Ensur e t hat the w ate r dra in h ose is no t kin ked or s quashed .
I f the si nk is 1000 h igher f rom t he fl oor, t he excess w a te r in ho se s c a nnot be drai ne d direc tl y
into the sink. It will be necessary todrain excess water from hoses into a bo wl or suitable
containe r tha t is held outside and lower th an t he s ink.
How to Drain Excess Water From Hoses
Syphon Conn ection
Th e w ast e connec ti on must b e at a height l e s s t han 100 0 mm (maxim u m) f ro m t he bottom o f t he d i s h.
The w at er dr ain h ose sho uld be f ixed .
Ins ert t he drain hos e int o a dra in pip e wi th a mini mum dia meter of 40mm, or l et i t run in to th e sink, mak ing s ure t o
avoid bend ing o r cr imping it . T he top of the h ose mus t be less tha n 10 00mm.
A
Counter
Front
Drain pipe
NOTE
The top of the hose
must be less than
1000mm.
φ 40mm
B
To Next Page
Loading...
