Using your dishwasher
Before first use
o Install the appliance as per the installation instructions contained
within this booklet.
o Add 1.5Kg specialist dishwasher salt to the dishwasher water
softener compartment and then fill with tap water. After this you
should set the water softener level.
o Fill the rinse aid dispenser and then set the rinse aid dosage.
Filling with dishwasher salt
IMPORTANT: You should only use salt that is specially
designed for use in a dishwasher. If any other type of salt is
used in the appliance (in particular table salt), it will damage
the water softener.
o Ideally you should fill the water softener with salt, just before you
are about to run a wash program. This will help to clear any salt
that may have overflowed from the water softener during the salt
filling process.
o Open the door of the dishwasher and
then remove the lower basket. The
basket should be empty when you
remove it.
o Turn the water softener cap
anticlockwise and remove it.
IMPORTANT: It is only necessary to do this when you fill the
container with salt for the first time.
o Pour salt into the water softener
compartment using the funnel that is
supplied with the appliance. You should
add approximately 1.5 kg of salt into the
water softener.
o Then pour tap water into the water
softener until it fills.
11
To Next Page
Loading...
Need help?
General
