Setting the rinse aid level
The amount of rinse aid that the dishwasher requires also depends on
the hardness of your water. You should experiment with the rinse aid
setting, until you find a level that gives the best results.
o On the first wash cycle, we would
recommend that the rinse aid level is set
to number 4.
o If you get water spots and poor drying
performance, then you should turn the
arrow anticlockwise and increase the
setting to the next number.
o You should continue to adjust the rinse aid level upwards until
you get no water spots.
o If you get cloudiness or streaking on your dishes, the rinse aid
level is set too high and it is causing foaming during the wash
cycle. Turn the arrow clockwise and lower the setting to the next
number.
Filling with dishwasher detergent
The detergent dispenser must be refilled at the start of each wash
cycle (apart from the Rinse wash program).
o Open the lid that closes over the detergent dispenser (1) and
place the detergent inside of the dispenser (2).
14
To Next Page
Loading...
Need help?
General
