11
o In case of power failure, the burners can be lit by carefully using
a match.
Automatic ignition with flame failure safety device
(BG2.1TCSS)
The appliance is fitted with a flame failure safety device on each
burner, which is designed to stop the flow of gas to the burner head in
the event of the flame going out.
To ignite a burner:
o Press in the control knob of the burner that you wish to light and
turn it anti-clockwise to the maximum position.
o If you keep the control knob depressed, the automatic ignition
for the burner will operate.
o You should hold down the control knob for 20 seconds after the
flame on the burner has lit.
o After this 20 second interval, turn the control knob to your
required setting between the maximum and minimum setting
symbols.
o To switch the burner off, turn the control knob fully clockwise to
the gas off position.
o In case of power failure, the burners can be lit by carefully using
a match.
Energy saving tips
PANS
BURNERS
Minimum
diametre
Maximum
diametre
Rapid 180 mm 220 mm
Auxiliary 80 mm 160 mm
o The diametre of the bottom of the pan should correspond to that
of the burner.
To Next Page
Loading...
