o Remove the hob from the worktop and remove any underside
protective covers.
o Disconnect the fixings holding the tap to the fascia panel and
separate the assembly.
o Disconnect the gas pipe from the gas tap, and then
disassemble them from the gas rail by removing the fixing
screws.
o When fitting a new tap, ensure that a new gasket is used.
o Reconnect the gas tap, perform a gas soundness test and
then reassemble the hob.
Electrical connection
This appliance must be installed by a qualified
person in accordance with the latest edition of the
I.E.E. Regulations and in compliance with Baumatic’s
instructions.
Before connecting the appliance, make sure that the supply voltage
marked on the rating plate corresponds with your mains supply
voltage.
o Cable type: H05 RRF 3 core x 0.75 mm³ (Type RR-F <HAR>
marked).
o The mains supply cable is supplied with this product.
Replacing the mains supply cable
If the mains supply cable is damaged, then it must be replaced by an
appropriate replacement which can be obtained from the Baumatic
Spares Department.
The mains supply cable should be replaced in accordance with the
following instructions:
o Switch the appliance off at your mains supply.
o Open the box of the supply board.
o Unscrew the clamp fixing the cable.
o Replace the cable with one of the same length and in accordance
with the specification given above.
23
To Next Page
Loading...
