16
Safety cut-off
o Based on the power level, each cooking zone is shut off after a
maximum preset time if no operations are performed such as a
change of power level.
o In principle, the way induction works is intrinsically safe. The
induction electronics provide temperature sensors at each
cooking zone located below the glass ceramic surface to monitor
the temperatures.
o Further temperature sensors along the heat sink protect the
electronics against overheating. The software may reduce the
power or switch off all cooking zones if a temperature which is
too high is measured.
o In addition, when the control panel detects an ambient
temperature greater than 95°C it shuts off all the elements. A
heating element that is shut off by the thermal protection can
only be turned back on when the ambient temperature drops
below 95°C.
Recall function
o The recall function enables settings to be recovered quickly when
the control has been switched off by the mains switch by
mistake.
o When the control has been switched off, you have 6 seconds to
switch it back on again. The execution of this function is only
available if at least one cooking zone was active and is confirmed
with an acoustic signal.
o If the appliance is switched back on within 6 seconds, it will
recall the power level of all cooking zones and the minutes and
seconds of all programmed timers.
Fan control (integrated cooling of the generator)
To Next Page
Loading...
