22
indicator lights will show you which wash program you have
currently selected.
o Press the Start/Reset button (4), after a few seconds, you will
hear the appliance continue with the new wash program that you
have selected.
o IMPORTANT: You should only change a wash program if the
detergent has not been released into the machine; otherwise you
may get poor wash results.
Pausing a wash program
o If you press the Start/Reset button (4) briefly during a wash
program, then the wash program will pause.
o The program indicator light will stop blinking.
o The dishwasher will make an audible noise once a minute, until
the Start/Reset button is pressed again.
o When the Start/Reset button is pressed again, the originally
selected wash program will restart.
At the end of a wash program
o At the end of a wash program, an audible signal will sound for a
period of time.
o Use the ON/OFF button (1) to switch the dishwasher off.
o IMPORTANT: You should leave the appliance for 15 minutes
BEFORE opening the door. This will allow the steam generated
from the final rinse(s) to dry the dishes.
o Carefully open the door of the appliance and leave it ajar for a
few minutes and allow any remaining steam to disperse.
o WARNING: Hot steam may escape when the door is first
opened, so care should be taken.
o Unload the dishwasher; you should take care in case any of the
items are still warm.
o IMPORTANT: If you leave the door of the dishwasher shut and
do not unload the dishwasher for a prolonged period of time,
then you may get water droplets reforming on the washload.
To Next Page
Loading...
