IMPORTANT: When the dishwasher is positioned in
the location where it will be used. Make sure that all
four feet are resting firmly on the floor, by pressing
down on each corner and checking that the appliance
stands still.
Connecting to the mains water supply
33
ed.
IMPORTANT: Do not connect the appliance to your mains
water supply using an old or an existing water inlet hose.
The inlet hose supplied with the dishwasher is the ONLY one
that should be us
o Connect the water inlet hose to a threaded water tap that has a
3/4” thread and to the inlet hose connector on the appliance.
o Fully tighten the inlet hose to the water tap and the dishwasher.
o The water supply to the appliance can also be connected to the
household hot water line such as a central heating system by
following the instructions above. The temperature must not
exceed 60°C.
o If you connect the appliance to a hot water supply, the wash cycle
times will be shortened by about 15 minutes and the wash
efficiency will be slightly reduced.
To Next Page
Loading...
