Baumatic BM90S - How to Keep Your Oven in Shape

Baumatic BM90S 900mm Built-In Oven User Manual 17
How to Keep Your Oven in Shape
Before cleaning your oven, or performing maintenance, disconnect it from the power supply.
To extend the life of your oven, it must be cleaned frequently, keeping in mind that:
• The enameled or stainless steel parts should be washed with lukewarm water without using any abrasive powders
or corrosive substances which could ruin them ;Stainless steel could get stained .If these stains are difficult to
remove, use special products available on the market. After cleaning, it is advisable to rinse thoroughly and dry.
• The inside of the oven should preferably be cleaned immediately after use ,when it is still warm ,with hot water
and soap ;The soap should be rinsed away and the interior dried thoroughly. Avoid using abrasive detergents (for
example cleaning powders, etc) and abrasive sponges for dishes or acids (such as lime scale –remover, etc…)
as these could damage the enamel .If the grease spots and dirt are particularly tough to remove, use a special
product for oven cleaning, following the instructions provided on the packet. Never use a steam cleaner for
cleaning inside of oven.
• If you use your oven for an extended period of time ,condensation may form. Dry it using a soft cloth.
• There is a rubber seal surrounding the oven opening which guarantees its perfect functioning .Check the condition
of this seal on a regular basis .If necessary, clean it and avoid using abrasive products or objects to do so. Should
it become damaged, please contact you’re nearest After-sales Service Center .We recommend you avoid using the
oven until it has been repaired.
• Never line the oven bottom with aluminum foil ,as the consequent accumulation of heat could compromise the
cooking and even damage the enamel.
• Clean the glass door using non-abrasive products or sponges and dry it with a soft cloth .
How to Remove The Oven door
For a more thorough clean, you can remove the oven door. Proceed as follows:
• Open the door fully;
• Lift up and turn the small levers situated on the two hinges;
• Grip the door on the two external sides, shut it slowly but not completely;
• Pull the door towards you , pulling it out of its seat;
• Reassemble the door by following the above procedures in reverse.
Replacing the Oven Lamp
WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility
of electric shock
• Disconnect the oven from the power supply by means of the omnipolar switch used to connect the appliance to
the electrical mains ;or unplug the appliance if the plug is accessible ;
• Remove the glass cover of the lamp - holder;
• Remove the lamp and replace with a lamp resistant to high temperatures (300°C) with the following characteristics:
• Voltage: 220-240V
• Wattage: 2X25W
• Type: E 14
• Replace the glass cover and reconnect the oven to the mains power supply
How to Keep Your Oven in Shape