38
o Put the oven burner back together, taking care not to change the
position of the igniter and safety device which are attached to
the burner. Replace the flame guard.
o Ensure that the appliance is in a safe condition, and then
reconnect it to the electricity supply.
Regulating the oven burner minimum setting
o Open the oven door fully and ignite the oven burner. You should
set the oven to maximum temperature, then close the oven door
and leave the appliance for 10 – 15 minutes.
o Reduce the temperature to its minimum setting and remove the
gas oven control knob.
o DISCONNECT THE APPLIANCE FROM THE ELECTRICITY
SUPPLY.
o Remove the main oven control knob.
o Unscrew the by-pass screws using a screwdriver. In order to
regulate the minimum setting, it is only necessary to unscrew
the by-pass screws by a few degrees when changing from liquid
gas (G30/G31) to methane gas (G20). In order to function with
G30/G31 the by-pass regulation screws must be screwed right
down.
o Refit the control knob, then turn it to the Max. position and then
back to Min. several times, checking that the flame is
maintained.
To Next Page
Loading...
