o The seal must adhere properly all the way around the door.
o If either seal is not adhering to the cabinet properly, then you
should either:-
1. Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
or
2. Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The
heat will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
IMPORTANT: AVOID HEATING THE DOOR SEAL ON HIGH HEAT
SETTINGS OR FOR PROLONGED PERIODS, WHICH MAY DAMAGE
THE DOOR SEAL. PRECAUTIONS SHOULD BE TAKEN WHEN
USING A HAIR DRYER. ANY DAMAGE CAUSED TO THE
APPLIANCE WILL NOT BE COVERED UNDER THE GUARANTEE
TERMS AND CONDITIONS.
Aperture dimensions and ventilation requirements
1) The appliance aperture should be:
Height- 1445 - 1465 mm
Depth- 550 mm
Width- 560 mm
23
To Next Page
Loading...
