30
om
d be consulted to
determine air vent requirements.
o
r install a mechanical ventilation
device (mechanical cooker hood).
o liance may call for additional
ventilation, either by the opening of a window, or by increasing
o ice for discharging the
products of combustion. Ensure that the ventilation rules and
o out at the top back edge of
the cooker, so make sure that the walls behind and near the
o
position the hob is level. When in position check that the cooker
rear
o Remember that the quantity of air necessary for combustion
Ga
o
dition of the Gas Safety
Installation and Use Regulations.
o
o In the UK, CORGI registered installers work to safe standards of
ccordance with
the current edition of BS 6172. Failure to install the cooker
o PORTANT: It is a requirement for a stability chain to be
information on this.
o If there are any other fuel burning appliances in the same ro
the current edition of BS 5440: Part 2: shoul
Ensure that the room containing the cooker is well ventilated,
keep natural ventilation holes o
Prolonged intensive use of the app
the level of the mechanical ventilation device (where present).
This cooker is not fitted with a dev
regulations are followed.
Excess steam from the oven, vents
cooker are resistant to heat, steam and condensation.
Your cooker must stand on a flat surface so that when it is in
is level by using a spirit level and adjust the 2 feet at the
and the 2 feet at the front if necessary.
must never be less than 2m³/h for each kW of power (see total
power in kW on the appliance rating plate).
s Safety (Installation and Use) Regulations
It is the law that all gas appliances are installed by competent
persons in accordance with the current e
It is in your interest and that of safety to ensure compliance with
the law.
practice. The cooker must also be installed in a
correctly could invalidate the warranty, liability claims and lead
to prosecution.
IM
fitted to the appliance. Please see page 34 for more
detailed
To Next Page
Loading...
