as adjustment (Conversion to LPG and flow adjustment).
All work must be carried out by a CORGI registered
engineer.
IMPO
supp d/or adjusting the
inimum flow of the burners.
o Remove the pan-stands, burners and
flame spreaders (A).
o U and replace it
with the stipulated injector for the new gas
supply (see table below).
o Reassemble all the burners carefully; in particular you should
make sure that the flame spreader is correctly placed on the
burner.
G
RTANT: Always isolate the cooker from the electricity
ly before changing the injectors an
m
nscrew the injector (B)
32
To Next Page
Loading...
