33
inimum flow adjustment for hob gas taps.
All work must be carried out by a CORGI registered
o Switch the burner
on and set the
knob at the
minimum
o Remove the knob
from the tap and
place a small
he
ap.
der to increase the gas flow
to decrease the gas flow.
when e
length of about 3 – 4 mm.
o For butane/propane gas, the adjusting screw
screwed in.
o Make sure that the flame does not go out by quickly turning
ve
further adjustments to the gas
flow, testing it again once the adjustment has been made.
M
engineer.
position.
bladed
screwdriver to t
outside the t
o Unscrew the adjusting screw, in or
or tighten the adjusting screw
o The correct adjustment is obtained th flame has a
must be tightly
o Refit the control knob.
from maximum flow to minimum flow. If it does then remo
the control knob and make
To Next Page
Loading...
