Baumatic BWD1212 - Cancelling Wash and Drying Cycles; How to Cancel a Wash Program; How to Cancel a Drying Program; Temperature Adjustment Button

Cancelling a wash program
9 Press the Start/pause button whilst a wash program is in
progress and the appliance will go into pause status.
o Turn the wash program selection knob until it is at the off
position (zero).
Before opening the porthole door, you MUST drain the
appliance; otherwise there may still be water in the
drum when you open the door.
9 Turn the wash program selection knob to the spin program
(number 12) then press the Start/pause button.
o The appliance will spin and drain the water that is left in the
drum.
o The washer dryer will stop automatically when it has completed
a wash cycle.
o The LCD display will show the word “End”.
o At the end of the drain program, the door will remain locked for
2 – 3 minutes before it is possible to open the door and take out
the garments.
Cancelling a drying program
o If you wish to cancel a drying program once the drying cycle is in
progress. You should press the Start/pause button and then
press the drying option button.
o The neon above the drying selection button will go out.
Temperature selection button
o If you press the temperature selection button, then the wash
temperature will reduce downwards from the one selected
automatically for a particular wash program.
o The wash temperature indicator neon will light next to the wash
temperature that has been selected.
o If the wash temperature indicator neon next to the symbol is
lit, then the wash cycle will be performed in cold water and not
heated.
19