Baumatic MEGAWDSS - Usage Advice and Initial Setup; Post-Wash Care and Initial Cycle

9
9 After each
wash, leave the
door ajar to
prevent the
rubber seal
from becoming
misshapen or
mouldy.
9 When the clothes
to be washed are
heavily soiled or
splattered with
mud, it is
advisable to run a
programme with
pre-wash.
9 Unless doing
half load
washing,
always put the
machine on
fully loaded to
save energy.
9 Do not use the
dryer function if
the clothes have
been treated with
any non-aqueous
solution.
9 Do not use the
dryer function for
items containing
any kind of
spongy rubber or
similar elastomer
materials.
9 The dryer must
be installed in a
well-ventilated
place, away
from the
influence of
gases from
other
appliances and
from defective
installations.
9 The lower
ventilation,
between the floor
and the base of
the machine must
not be obstructed
(by carpet, cloths,
etc.).
9 When the
machine has
just been
installed, or
after a long
time without it
being used, it is
advisable to run
a washing
programme
with the
machine empty,
to eliminate any
rusty water in
the tubes.