10
Using your MEGAWDSS
CAUTION: (*VERY IMPORTANT*) –
You must ensure that the
transportation bolts have been
removed before you attempt to
use your Washer Dryer,
OTHERWISE you will damage or
destroy your appliance. See page
32 for instructions.
Only once you are sure this has been done (with the
appliance successfully installed) can you do the
following
:
1) Plug in your machine
2) Turn on the water supply
Note on using your
Washer Dryer for
the first time:
There may be water
left inside your
machine after factory
tests and trials.
• The first time you run a
wash cycle, you should not
put laundry in your machine
as it may need to drain water.
• Pour half a measuring cup of
normal or all purpose detergent
into the middle compartment
(compartment II as shown on
page 13) of your detergent
dispenser and select a short
washing programme.
• Start the programme.
• Wait until the programme
finishes.
*FOR NORMAL USE, SEE NEXT PAGE
To Next Page
Loading...
