23
CONTINUOUS WASH-DRY CYCLE
This feature of your appliance allows a drying
cycle to follow on from a washing cycle
without your having to go anywhere near your
washer-dryer!
NOTE: You will need to set your washer-dryer to
perform this function if you do not want it to wash
and stop and then have to dry separately.
Set your washing programme as you would normally,
but REMEMBER THAT YOU MUST SELECT THE HALF-
LOAD FEATURE.
Set your drying timer as you would normally do for a
drying programme.
Bear the following in mind when setting this function
: Do NOT press the
‘No spin’ button.
• Set the drying time
using the timer knob,
remembering that
several short spells
are better than a long
pre-programmed one.
• Select the washing
programme,
remembering that
your appliance will
not
perform a drying
cycle if the wool
programme has been
selected.
• To start the
machine, press the
‘ON/OFF’ button.
• At the end of the
wash and dry
programme, the timer
knob will stop at
position “0”.
• Press the ON/OFF
button and
disconnect from the
power supply.
• Remove your dried
wash load.
IMPORTANT REMINDERS:
Do not dry clothes that contain plastic (including
acrylic), foam or rubber or similar materials, or those
that have not been cleaned in a water solution. DO
NOT USE A PLASTIC DETERGENT DISPENSER ORB IN
THE DRUM!
To Next Page
Loading...
