22
3) Set the programmer
knob to the STOP point
(just before ‘7’ on the
dial) for a drying cycle
using high heat
. For a
low
heat drying cycle, set
the knob to the STOP
point between ‘11’ and
‘12’ on the dial.
NOTE
YOUR MACHINE WILL NOT PERFORM
A DRYING CYCLE IF THE WOOL
PROGRAMME HAS BEEN SELECTED.
4) Press the ON/OFF switch.
At the end of the drying cycle, there is a 10 minute cool
down period. This will minimise creasing due to allowing
the fabric to cool down gently.
NOTE:
Normally, threads from your washing will be discharged
through the exhaust duct. However, if you use the machine as a drier
only, or if you have washed and dried items that tend to shed threads,
you should
remove the washing and perform a rinse and spin cycle
.
This will remove any threads from the drum and prevent them from re-
depositing during the next cycle.
WARNING! During the operating cycle, the glass
porthole will heat up – try to avoid touching it.
• At the end of the drying cycle,
the timer knob will stop at
position ‘0’. When this
happens:
Press the On/Off
button before
removing your dried
washing.
NEVER ATTEMPT TO DRY OR SPIN
WOOLLEN ITEMS TOO QUICKLY – IT
To Next Page
Loading...
