o On the position that you have marked,
cut the inlet hose off vertically.
o Connect the inlet hose to either side of
the water filter.
3) Place the appliance side
end of the inlet hose into a
container that you can run
water into.
o Fully open the water tap
that the inlet hose is
connected to. If water
does not come out, then
check that you have
fully opened the water
tap.
o Leave the tap open until clear water is flowing out of the
appliance side end of the inlet hose.
IMPORTANT- The running of water through the inlet hose and filter
must be done, to make sure that any impurities from the
manufacturing process are washed out.
o Turn the tap off again.
36
To Next Page
Loading...
