Maintenance Disposal
50 BUG 3/2/20 Basic Feed Unit
5.96064.02 Baumüller Nürnberg GmbH
7.2 Disposal
The equipment consists mainly of the following components and materials:
Component Material
Housing, various intermediate panels, fan impeller, mounting
panels
Sheet steel or aluminium
Heat sink of the power section Aluminium
Various spacer bolts Steel
Various spacers, housing of current converter and unit fan,
etc.
Plastic
Bus bars in the power stage Copper/aluminium
Cable harnesses PVC- or Teflon-insulated copper wire
Power electronics: Module diodes mounted on a heat sink Metal base plate, semiconductor chip, plastic
housing, various insulation materials
PCBs on which all the open- and closed-loop electronics are
mounted
Base material: Epoxy-resin fibreglass woven
material, copper-coated on both sides and
plated-through, various electronic components
such as condensors, resistors, relays, semi-
conductors, etc.
For technical reasons, electronic components might need to contain dangerous materials, so you
should not open them.
If the components are used correctly, there is no danger to human beings or to the environment.
In case of fire, dangerous compounds can be generated or released.
You must dispose of or recycle equipment or components according to national regulations as well as
any applicable local or regional ordinances.
To Next Page
Loading...
Need help?
General
