Documento riservato – A solo uso interno / Confidential document – Internal use only
If a fault occurs, the display reads out an error message identifying
it (es. E 10):
To RESET the gas boiler, turn selector (Figure 2) to “R” for at least 2 seconds. If the fault
persists, call an authorised service centre.
Note: It is possible to carry out n° 5 relighting attempts in a row, after which the RESET function
is disabled and the gas boiler still blocked.
To carry out a new RESET attempt, turn the selector (figure 2) in OFF position for at least 2
seconds.
Resetting
errors
Safety device indicators - activation
To Next Page
Loading...
