C. Form of operation 7
D. Ebullition thermostat 10
E. ON / OFF button - ignite / extinguish Error!
Unknown switch argument.
6
F. Alarm reset - cancel alarm 9
G. Manual worm conveyor/auger - forwards 8
H. Manual worm conveyor/auger - backwards 8
I. Light diodes 7
J. Set = boiler temperature. 6
K. High output 8
L. Low output 8
M. Firing at intervals 8
P. Pump 10
R. REG Error! Unknown switch argument. 7
Fig. 1.3
Remember:
Always ensure that you have a pen and paper ready every time you adjust the
settings on the control. Suggestions for tables can be seen on the last page of this
instruction.
When an adjustment is made on a setting, the information regarding this will
be shown in the display for approx. 10 seconds after the last adjustment or until
another function is carried out.
To Next Page
Loading...
