(E) Ignite takes place by pressing the ON/OFF button (E) and this will be displayed in the light
diode above the button..
(J) Boiler temp. is adjusted by keeping set (J) pressed in and simultaneously pressing on + or – on REG
(R). The temperature can be adjusted from 60 to 85°C. The ideal temperature is 80°C
since it is "good for the boiler" to have a comparatively high temperature. (When "set"
is pressed, the diode will light up - "set" and the adjusted temperature is shown on the
display.
Page 6
(R) Regulation
Here the adjustable parameters can be adjusted up and down in value.
(B) Menu With this button it is possible to switch between which of the 4 temperatures you wish
to have shown in the display. However, in the set-up menu, it is used to "step" through
the set-up points. - (See temperature display on the next page). This is also used for
programming, as shown on page Error! Unknown switch argument. Error! Unknown
switch argument.9.
(A) (I) Temp. indication - with the menu button (B) it is possible to set the desired temperature in the
display (A).
• Every time you press the menu button this will switch to the next temperature
(displayed on the light diodes (I)).
The temperatures which can be shown are:
To Next Page
Loading...
