Baxton Studio ABBIE DAYBED-F/T - User Manual

NO PART LIST
QTY
BACK REST
1PC
SIDE PANEL
(L)
FRONT
SIDE RAIL
LEG
ITEM
HARDWARE
QTY
JCBB SCREW
M8 x 20MM
L - KEY
M5 x 65MM
1PC
1PC
4PCS
20PCS
STEP 1
STEP 3
1
2
3
4
5
ABBIE DAYBED-F/T
ABBIE DAYBED-Q/T
6
SIDE PANEL
(R)
Please do not tighten the hardware until the entire assembly is completed.
7
1PC
8
SLAT
2 SET
SPRING WASHER
FLAT WASHER
(BIG)
FLAT WASHER
(SMALL)
L - KEY
M4 x 100MM
SCREW
M4 x 32MM
SCREW
M4 x 16MM
4PCS
12PCS
24PCS
16PCS
22PCS
1PC
1PC
A
B
20PCS
JCBC SCREW
M6 x 50MM
C
D
E
F
G
H
I
J
9
7pcs
2PCS
2PCS
BACK
SIDE RAIL
1PC
1PC
SLAT
SUPPORT
SUPPORT
LEG
STOPPER
Begin assembly by attaching each Leg (6) to the bottom of the
Side Panel (2) & (3) securing with 2 Allen Bolt (B) per panel using
L-key (H).
STEP 2
Attach the Front Rail (4) and Back Rail (5) to the Side Panel (2) & (3)
aligning holes and securing with 2 Allen Bolts (A) per each end using
L-key (I). (DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)
Attach the Back Rest (1) to the back of each Side Panel (2) & (3) by
aligning the hole and securing with 2 Allen Bolts (B), 2 Spring Washer
(C), 2 Flat Washer (D) from the back side per each end using L-key (H).
(DO NOT FULLY TIGHTEN BOLTS FOR THIS STEP)
STEP 4
Secure 2 Support Leg (9) to the Slat Support (8) as shown on step 4.1.
Insert the pre-set metal on Slat Support (8) to the metal bracket on each
side of Side Panel (2) & (3). Then securing the metal bracket as shown
in step 4.3 with 1 Screw (G) each side using Phillips Head Screwdriver
(NOT INCLUDED)
10
11
12
13
14
15
1PC
1PC
TRUNDLE
FRONT RAIL
TRUNDLE
BACK RAIL
TRUNDLE
SIDE RAIL
2PCS
SLAT
5pcs
2 SET
SLAT
SUPPORT
3PCS
6PCS
CASTOR
A
I
6
B
H
H
B
D
C
1
STEP 4.2
STEP 4.3
8
G
STEP 4.1
8
9
2
4
3
8
1
2
4
3
1
4
2
5
3
2
3

Baxton Studio ABBIE DAYBED-F/T Specifications