ENUSER MANUAL STI
8
4. INSTALLATION
UNPACKING
Carefully take the scale out of its package, make it sure its not damaged and all accessories are included.
Accessories:
1. Scale
2. Adaptor
3. Stainless steel pan
4. Product manual
Keep the packaging material for your future use.
LEVEL ADJUSTING
Place the scale on a table.
Check the water mark. If bubble is not centre, adjust the leveling feet until reach centre. Check the level when you change the
location.
CONECT ADAPTOR
• To charge the battery insert the adaptor pin to jack. Adaptor simply plug into the mains power.
The scale no needs to be turned on.
• The battery should be charged for 4 hours for full capacity.
• The symbol status of the battery
Battery voltage has dropped
Fully charged
• Do not use any other type of power adaptor than the one supplied with the scale.
• Verify that the AC power socket outlet is properly protected
INSTALLATION
• Place the scale on a table.
• Insert the pole into the bottom bracket.
• Close the bottom cover by using screws
• Carefully place the pan to the four holes on the top cover
• Adjust the water mark bubble level.
• Connect the adaptor pin to the adaptor jack.
Adaptor jack is locating below the right side of the scale.
To Next Page
Loading...
Need help?
General
