Conguring your speaker from Android
Power on your speaker and wait for a white light indicating it has nished its initialisation.
Swipe down from the top of the screen and choose to search for a new wi network. Select your new speaker from the list
of available wi networks.
Open a web browser and navigate to www.bayanaudio.com/setup
You will be prompted for a name for the speaker – typically we recommend naming the speaker by the name of the room the
speaker is located in (e.g. kitchen, living room, bedroom).
Next you will need to select the name of the Wi-Fi network to which you wish to connect the speaker from the ‘Network
Name’ drop down selection box. If your network is not listed, please check the router is turned on, and that your android
device is connected to it. You can refresh the list of networks if necessary.
Enter the ‘Password’ for your Wi-Fi network – you may nd this written on the bottom of your Wi-Fi router unless you have
changed the password at some point.
Tap ‘Connect’ and wait for a message saying ‘You are connected’.
Your speaker will now connect to your Wi-Fi and is ready to use.
Conguring your speaker from iOS
Power on your speaker and wait for a white light indicating it has nished its initialisation.
Open Settings, Wi-Fi, then select your new speaker. You will now be asked to choose the name for your speaker – you may
nd it helpful to call the speaker by the name of the room it is in if you have a number of speakers on your network – for
example ‘Master Bedroom’ or ‘Living Room’
To Next Page
Loading...