Quick Start (continued)
Position your speakers as desired and locate the nearest mains power outlet to the speakers. The active speaker may go on
the left or the right – it does not matter at this stage.
Connect the active speaker to the passive speaker using the -way speaker connection cable. Tighten the locking nut being
careful not to cross the threads – if it does not screw on easily, please loosen it and start again!
Locate the switch labelled ‘L MONO R’ on the rear of the active speaker. If the active speaker is on the left side, select ‘L’, if it
is on the Right side, select ‘R’. If the speaker is to be used on its own as a mono speaker, select ‘MONO’.
You may choose at this stage to connect your speaker to the network using an Ethernet cable. This is not a requirement as
Wi-Fi may be congured later. However, using Ethernet cables to connect your speakers to the router may result in better
network performance for your other applications.
Turn on the power switch on the rear of the active speaker – a RED light will illuminate on the front of the active speaker.
Press the ‘Power’ button on the remote control, or alternatively short-press the ‘Volume / Input’ knob at the rear of the ac-
tive speaker. The RED light will ash indicating that the speaker is initialising.
Once the speaker initialisation is complete, the active speaker will display a WHITE light showing that it is on, and the net-
work input is selected.
If you have used an Ethernet cable to connect your speaker to the network, then setup is now complete, however you may
wish to read the StreamQ App section of the manual to see how to change the name of your speaker. If you wish to use
Wi-Fi, please refer to the following instructions relevant to your mobile device / Network:
To Next Page
Loading...
