1- General Information
Read this guide before installing the meter.
In case of incorrect mounting YGHP’s guarantee obligations no longer apply.
Please note that the following installation conditions must be obeyed:
Pressure Requirement: PN16/PS16.
Environmental Class: E1, M1, A
Installation requirement: There must be a distance of minimum 25 cm
between signal cables and other installations
If medium temperature is below 10°C or above 90°C in flow sensor, It’s
recommended that the calculator be wall-mounted.
Note: Seal or any safety marks on the meter must not be damaged or
removed, and doing so will void the warranty and calibration of the meter.
2- Installation
Installation diagram
To Next Page
Loading...