CTI 1 Manual V2 Aug 11
4
INTRODUCTION
GENERAL
The CTI/1 is designed to provide conversion from RS422/485 serial telemetry to
BBV Coax Telemetry based systems.
Up the Coax telemetry allows upgrading of static cameras to PTZ without the
need for additional cabling.
The RS422/485 input is auto detecting. The CTI/1 will understand BBV RS422 &
Pelco P @ 9600, N, 8, 1.
1 x BNC output provides Coax Telemetry, connecting to a single receiver.
1 x BNC output provides Video Loop Through.
Each unit is supplied with a 12Vdc Power Supply, Manual & Adhesive Fixings.
Please Note: The CTI/1 supports eight addresses only
Protocols supported are: BBV & Pelco P
The CTI/1 has been tested with the BBV FBM Matrix, BBV TX1500 Matrix, BBV
TX400DC/RS485 and a number of products that transmit Pelco P 9600 N81,
BBV ALWAYS RECOMMENDS THAT ALL SYSTEMS
ARE BENCH TESTED BEFORE INSTALLATION
To Next Page
Loading...