Page 12 CPS/MAX/0617
Operation
Use the Handlebar Height Adjustment Lever to set handlebar height.
Pull up the Clutch Lever. This will automatically release the lever Locking Clip.
Ensure the red Forward/Reverse Lever is in the correct position to move forward: if the
handlebars are positioned over the engine then this lever should be in the fully back position.
Engage drive to the cutter bar by using the PTO Lever: if the handlebars are positioned over the
engine then pull the PTO Lever towards you.
Using the Wheel Speed Lever, select 1st gear.
Raise the throttle slightly, release the Clutch Lever gently and fully, keeping the red Engine Stop
(OPC) Lever depressed as the engine will stop if this is released.
Commence work.
IMPORTANT! NEVER USE MORE THAN ¼ THROTTLE WHEN
THE CUTTER BAR IS OPERATING
!
To Next Page
Loading...
