BCS 630 - Safety Precautions

BCS Crusader Power Scythes
CPS/MAX/0617 Page 9
Safety Precautions
During transportation of the machine, or when it is not in
use,installthebladeguard(A)onthebar(gure14).
Always wear HEAVY GLOVES to protect your hands whilst
working on the equipment.
READ and observe all warning labels on the machine and
implements(gure15).
Always wear appropriate work clothes whilst operating the
machine, always wear safety footwear.
DO NOT USEthemachinenearchildrenoranimals(gure
16).
The machine operator is responsible for any damage to
persons or property.
Always walk with the machine - DO NOT RUN.
NEVER work on slopes of more than 20
o
and always work
across the face of a slope (side to side), NEVER up and
down. NEVER use the machine on a bank where there is a
possibility of the machine sliding down the slope.
Always disengage the power take-off (PTO) when changing
direction or location of operation.
DO NOT replace the blades or attempt to undertake any
maintenance of the cutter bar while the engine is running.
ONLYqualiedpersonsshouldoperatethemachine.
If any abnormal vibrations occur STOP the engine immediately
and visually inspect the machine and implement for any signs
of damage.
IMPORTANT: Read all machine and implement manuals
thoroughly before using the cutter bar.
Figure 14
Figure 15
Figure 16