EasyManuals Logo

Bdcom S2956 series User Manual

Bdcom S2956 series
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
S2956 Hardware Installation Manual
- 14 -
Chapter 4 Maintaining the Switch
Caution:
z Before opening the chassis, make sure that you have released the static you
carried and then turn off the power on-off of the switch. Before operating any step
in Appendix B, read the section “Safety Advice”.
z Before performing operations beside the power source or on the chassis, turn off
the power on-off and plug out the power cable.
4.1 Opening the Chassis
This section describes how to open the cover of the switch, required tools and
operation methods.
Caution:
When the power cable still connects the power source, do not touch it.
When you open the cover the switch, you may use the following tools: These tools are:
z Crossed screwdriver
z Static armguard
Perform the following steps to open the cover of the switch:
1) Turn off the power on-off of the switch.
2) Plug out all cables connected the back of the switch.
3) Take out the bolt from the chassis with the screwdriver.
Note:
The chassis comprises of two parts: cover and bottom.
4) Open the cover by holding two sides of the cover towards the direction of the
arrow key shown in the following figure:

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bdcom S2956 series and is the answer not in the manual?

Bdcom S2956 series Specifications

General IconGeneral
BrandBdcom
ModelS2956 series
CategorySwitch
LanguageEnglish

Related product manuals